How to Replace Bladed Auger Teeth (A-series Augers)
If your A-series auger teeth look anything like the below you should replace them rather sooner than later. The tungsten tip A-Series Auger tooth will wear most on the leading edge of the tungsten. You should see a valley type pattern on the underside of the teeth. In the following, you will find a guide on how remove and install worn auger teeth for A-series augers. If you need to install tapered teeth or rotating rock picks check out our blog. In the meantime, you can also watch our video . Removing Bladed Auger Teeth Bladed teeth are found on all A series earth augers. Follow these first steps to remove them. 1. If a nylon pin (Pinloc) is in place, remove it using a hole puncher or by breaking the pin. Pinloc is available on A4 augers only. 2. Place a punch in the groove on the back of the tooth, Tap on the back of the punch with a hammer to dislodge the tooth. This should also release the Rubberloc, if used. 3. If the tooth is jammed or difficult to remove, a pin punch or ce...