Join our mailing list

* indicates required






Popular posts from this blog

Rocky's Excavations review the Digga Slasher

Image
Rocky's Excavations and the Digga Slasher Rocky Toohey and Bregan Lockett business owners at Rocky's Excavations explained, their most used Digga attachment is the Slasher - for land clearing, grass and weed slashing.   “The slasher is always impressing our customers with just how much it can slash and the different types of weeds and lantana it removes so quickly. The Digga slasher removes small trees cutting them up to nothing. Working on acreage properties in the summer the Digga slasher is our most requested attachment for land maintenance, fence line clearing and acreage upkeep.”   Benefits of the Digga Slasher Built for slashing and clearing grasslands and low-level shrubbery the  Digga Slasher  is the introductory offering in the Digga range of forestry and vegetation management attachments.  It is perfect for smaller property maintenance, clearing light scrub, tidying fence lines, general landscaping, roadway maintenance and parks maintenance.  Available to suit mini
Read more...

Specialising in excavations and earthworks, DNA Contract Services say Digga Machinery Attachments "give the best bang for buck!"

Image
Sydney wide DNA Contract Services are a well-established company specialising in excavations, earthworks, haulage and sediment control and trusted by some of Australia’s biggest builders. They were contracted as part of a project with Channel 7’s Better Homes and Gardens to drill piers for a granny flat behind a house in Blacktown, NSW and decided the Digga PD6 Auger Drive unit was the tool for the job. Attached to their 5.5 tonne Hitachi excavator they were never going to have any problems and DNA told us the PD6 drilled through with ease. Alex Vella of DNA Contract Services commented: “I have been using Digga now for 2 years and will continue to do so. DNA have used many other products on the market but find Digga to produce plenty of power at an affordable cost. In my opinion, Digga products give the best bang for buck!”
Read more...

How to Replace Bladed Auger Teeth (A-series Augers)

Image
If your A-series auger teeth look anything like the below you should replace them rather sooner than later. The tungsten tip A-Series Auger tooth will wear most on the leading edge of the tungsten. You should see a valley type pattern on the underside of the teeth. In the following, you will find a guide on how remove and install worn auger teeth for A-series augers. If you need to install tapered teeth or rotating rock picks check out our blog. In the meantime, you can also watch our video .  Removing Bladed Auger Teeth Bladed teeth are found on all A series earth augers. Follow these first steps to remove them. 1. If a nylon pin (Pinloc) is in place, remove it using a hole puncher or by breaking the pin. Pinloc is available on A4 augers only. 2. Place a punch in the groove on the back of the tooth, Tap on the back of the punch with a hammer to dislodge the tooth. This should also release the Rubberloc, if used. 3. If the tooth is jammed or difficult to remove, a pin punch or centre
Read more...